Just how to upgrade the Jeep Wrangler with led interior light package


  • In this message, we're mosting likely to be having a look at a 2019 brand-new LED interior package for the Jeep JK Wrangler.
  • This get includes plug-and-play replacements for your dome map and license plate lights.
  • It's likewise offered in a range of shade temperatures in addition to outcome levels. it can be installed in the house in your garage with basic hand devices and only takes a few minutes. Just that easy.


We get access to the stock map lights. We will go ahead and also make use of a plastic tree removal tool to take off this plastic cover and it ought to pop off quickly. Just established that aside, we'll remove our manufacturing facility light bulbs, simply draw on them a little bit and they need to come right out. Next off, we would advise using gloves at this point due to the fact that these canbus led T10 light bulbs will get hot, you can after that connect in your T10 LED replacement light bulbs. Prior to re-installing that plastic cover, you can go on and test them for feature and then just slide that plastic cover right back on.


With our map light finished, we can now relocate in reverse for the dome light to access your factory dome light. We will make use of that same plastic trim removal tool to remove this plastic cover press in and below the side and it should come right out. The clear plastic cover does not in fact come right off for the dome light and if this black shadow comes off as well do not be surprised.

That's entirely typical, it simply clips back in with four tabs, 2 on either side to obtain your factory dome light. You'll merely take out these little tabs on either side and the bulb should slide right out. Before you put your LED bulb upgrade in, go on and squeeze on these tabs somewhat so that the bulb is safe and wonderful. When you pop it in with that done, go on and also appear your led replacement bulb with our interior led light bulbs.

After completed, we can proceed as well as proceed to the license plate. Until now, the installment of your license plate light bulb might not be any simpler. You will pinch 2 tabs on either side of the license plate housing as well as turn counterclockwise to launch it.

You'll remove your supply bulb as well as plug in your T10 LED canbus replacement light bulb. This light bulb is much better to be non-polar sensitive so we don't need to examine the connection. When you're sure that it's linked appropriately, re-secure the housing, as well as you're finished with your brand-new LED kit set up. You'll currently delight in much better presence and an awesome tidy contemporary appearance.